Today is...
Tuesday, July 23, 2019
Welcome to Control.com, the global online
community of automation professionals.
Featured Video...
Featured Video
Wiring and programming your servos and I/O just got a lot easier...
Our Advertisers
Help keep our servers running...
Patronize our advertisers!
Visit our Post Archive
GE Fanuc rx7i PLC Not Going into Run Mode
PLC goes into halt mode after detecting 'CONTROLLER CPU HARDWARE FAILURE' fault
By majji raju on 21 July, 2014 - 1:27 am

CPU gone to halt mode after detecting a fault 'CONTROLLER CPU HARDWARE FAILURE'
ERROR CODE '1200', GROUP 13, ACTION '3:FATAL' TASK NO '0'

And other fault is "NON CRITICAL CPU SOFTWARE EVENT". The fault table is not clearing as CPU is not in run mode. How to go upon to restore the defect using proficy machine edition vrsion 6.0? The 'CPU OK' LED continuously blinking.

ERROR 8097: CONTROLLER CPU HALTED [0 x05][0x94] [0x 15003680] selected memory cannot be cleared. RX 7I ICE 698 CPE 030 USING MACHINE EDITION