Turbine steam flow always showing low (i.e. 4 TO 5 TPH) compare to boiler output. This different is increasing while load is increase. Both side same value used for steam compensation (max pressure and temperature value as per OEM recom)---is there any issue?
Boiler side 0-5000 MMWC TX range used and turbine side 0-10000 MMWX TX used. There is no much long from boiler to turbine and pipe insulation also good. Let me know any correction need in DCS.
In general how to desire the max TPH value for maxium DP in TX or DCS. What are all the parameters need to consider for that (like density, pipe dia, temp, PR, etc)?
Boiler side 0-5000 MMWC TX range used and turbine side 0-10000 MMWX TX used. There is no much long from boiler to turbine and pipe insulation also good. Let me know any correction need in DCS.
In general how to desire the max TPH value for maxium DP in TX or DCS. What are all the parameters need to consider for that (like density, pipe dia, temp, PR, etc)?