Creating a new .hmb File for MARK VI HMI

D

Thread Starter

Djafer

Dear All

I had a hard drive failure on PC. I had a good Ghost image of the machine that I was able to restore into the machine since it was only a new hard drive and not a new PC. This was a fairly simple repair since I was restoring to the same hardware (motherboard, drivers etc.).

The toolbox working fine (only minor Difference); TCI working perfect, but when I open Complicity show only background (no communication). So I want to proceed for put/get from SDB rebuild the .hmb file, but the turbine is online. please advise me if I can proceed for put/get from SDB rebuild the .hmb file on line (means turbine online).

Regards
 
Top